UltraView PTZ
User Manual
32
Alarms and relays
The alarms and relays menu lets you program presets for alarms and program relays, and set alarm reporting.
Note: Alarms are available only when using a UPIB housing card.
Alarm programming
To set an alarm preset, do the following:
5. Center the crosshairs on the center of the area you want
to mask off and press the iris + button (Figure 65).
Figure 65.Privacy mask set
6. Using the joystick, set the size of the mask by pushing up
or down to increase or decrease the vertical size of the
mask (Figure 66), or left or right to increase or decrease
the horizontal size of the mask.
7. When finished, press iris + again to set the mask and
return to the Privacy masks menu.
8. Repeat steps 3 through 7 for additional masks.
Figure 66.Privacy mask adjust
1. Select 1 from the Alarms and relays menu. The Alarm
programming menu displays (Figure 67).
2. Use the joystick to select alarms 01 through 04 and press
iris+ to set a preset number that corresponds with the
alarm.
Figure 67.Alarm programming menu
To Next Page
Loading...
