UltraView PTZ
User Manual
34
To enable passwords, do the following:
1. From Program select menu 2, select System startup. The Password protection menu displays.
2. Select 2.
You have now enabled passwords, which means when you log onto the camera with a controlling device,
you’ll need to enter that password to access any programming.
To disable passwords, do the following:
1. From Program select menu 2, select System startup. The Password protection menu displays.
2. Select 1.
You have now disabled passwords. Anyone can access the camera’s programming without a password.
Installation date
To customize your installation date, do the following:
2. Select 3. The Change password menu displays
(Figure 71).
3. Using the number selecting line, enter four numbers for
your password.
4. Enter those same numbers again when prompted.
5. Password saved is displayed onscreen, and the menu
exits back to the Password protection menu (Figure 70
on page 33).
Figure 71.Change password menu
CAUTION: If you change the password from the default, when you select Password disable, the password is
changed back to the default automatically. So, if you ever reenable passwords, make sure to change
the password again, or remember that the password is the default password (3477).
1. From Program select menu 2, select System startup. The
Password protection screen displays.
2. Using the joystick, pan right, past the Password
protection screen. The Installation date menu displays
(Figure 72).
3. Press iris + to edit the date.
4. Using the joystick to navigate the number selection
string, enter the installation date in YY/MM/DD format.
5. Once you have verified that it is the correct date, press
iris + again to save the date.
Note: Once set, the installation date can only be cleared by doing a
Clear all to reset to factory defaults.
Figure 72.Installation date menu
To Next Page
Loading...
