Chapter 1
Programming
35
Power-up action
You can program the UltraView PTZ to perform a certain action when it first powers up. The power-up action
default is home.
To set a power-up action, do the following:
Position reporting
Position reporting provides the capability for a remote device to get pan, tilt, and zoom position information for
doing analysis on the image data. This feature is only supported when the unit is in the Interlogix Impac
RS-485 9600 protocol mode.
To set position reporting, do the following:
1. From Program select menu 2, select System startup. The
Password protection screen displays.
2. Using the joystick, navigate right, past the Password
protection and Installation date screens, to the Power-up
action screen (Figure 73).
3. Choose the action you want the camera to take when it
first powers up.
• Select 1 for none, or no actions.
• Select 2 for home.
• Select 3 for a specific preset. Press iris + to enter the
three-digit-number (000 to 128) of the preset you
want to use.
• Select 4 for a specific tour. Press iris + to enter the
one-digit number (1 to 8) of the tour you want to use.
• Select 5 for autopan.
Figure 73.Power-up action menu
1. From Program select menu 2, select System startup. The
Password protection screen displays.
2. Using the joystick, navigate right, past the Password
protection, Installation date, and Power-up action
screens, to the Position reporting screen (Figure 74).
3. Press 1 to disable, or press 2 to enable.
Figure 74.Position reporting menu
E
CAUTION: If more than one unit has the positioning reporting feature enabled and the units share the same
control data line, enabling this feature may flood the RS-485 communication lines.
To Next Page
Loading...
