Chapter 1
Programming
17
Shutter speed
Select the shutter speed by choosing the number that corresponds
with the desired speed for either NTSC (Figure 33) or PAL
(Figure 34) camera.
During pan/tilt operation, shutter speed is controlled
automatically by the camera. To use the settings in the Shutter
speed menu during live video, press the iris + button. Press iris -
or move the camera to return the settings to automatic (Auto is
default).
Note: When you set the shutter speed to anything other than automatic,
the setting will override the manual return to autoiris control,
making the iris always fully automatic.
While the camera is moving in low light conditions, enable
Autoslow shutter so that shutter speed can be adjusted to enhance
the video image.
See Exposure control on page 36 for more information about light
settings.
Figure 33.Shutter speed menu (NTSC)
Figure 34.Shutter speed menu (PAL)
Site number display
Enable or disable the display of the camera site number in the
upper left-hand corner of the monitor screen (Figure 35).
• Select option 1 to disable site number display.
• Select option 2 to enable site number display.
• Select option 3 to enter diagnostic mode.
Note: When you re-enter the menus after being in live mode, the
diagnostics mode is automatically turned off. So when you exit
from the first menu and return to live view, the diagnostics will not
display. Diagnostics is a temperary setting that displays raw pan,
tilt, zoom, and protocol selected information on your live video
screen. This information is intended for use when contacting
technical support.
Figure 35.Site number display menu
To Next Page
Loading...
