UltraView PTZ
User Manual
30
To better understand preset tour programming, review the following abbreviations:
• ST = Step of the preset. May have up to 64 presets and must be set for a preset tour.
• POS = Preset number assigned to that step of the tour.
• DW = Dwell time, or amount of time the position is held before moving.
• SPD = Speed that the camera travels to the next preset.
• ZM (also FZ or ZO) = Freezes the last image while moving to the next preset. ZO zooms out first,
moves to the next preset, then zooms to the preset number’s zoom factor.
• TTL = Turns the preset title on or off.
5. For each step programmed, the following information
must be entered:
• The preset number (0 to 128).
• The dwell time at each step (1 to 31 seconds). The
default dwell time is 2 seconds.
• The speed at which the camera moves between
presets. There are three speed settings: SLW (slow),
MED (medium), and FST (fast). Press the iris + to
cycle through the speed settings.
• The zoom level (freeze (FZ) or zoomed out (ZO) or
normal (--)).
• The title (TTL) (on or off).
6. To finish programming a tour, select the step number and
press the iris - key. The PTZ tour programming menu
displays.
Note: If the step number is not selected, pressing the iris - key
will delete the step.
7. Navigate to option 2 to play the tour, to verify, and press
the iris + to exit back to the previous menu.
To Next Page
Loading...
