Page 18 of 20
Troubleshooting
Problem:
• I am trying to turn on a module associated to channel 1,
but it will not turn on.
• My programmed events will not automatically execute.
Solution:
• Check to be sure there is power supplied to the module.
• Check to be sure that the lightbulb is not bad.
• The module might be associated as a ‘FULL OFF’ light-
level. Re-associate the module (see page 9) as a ‘FULL
ON’ or as a dimmed light level.
• After programming your events, press MODE until the
LCD display indicates ‘AUTO’ or ‘AUTORAND’ mode.
To Next Page
Loading...