Page 17 of 20
Troubleshooting
Problem:
• Every time I try to INCLUDE or DELETE modules to my
network, I keep getting errors (red LED flashes)
• After I perform a controller replication, neither controller
controls anything at all.
Solution:
• The controller might be a Secondary Controller. Only a
Primary Controller may be used to INCLUDE or
DELETE modules into or from a network. Use the
Primary Controller to INCLUDE or DELETE.
• The module might be part of a different network. Reset
the module by pressing and releasing DELETE on the
primary controller, then push the program button on the
module. Now you may INCLUDE the module using the
Primary Controller. (See page 7).
• You have copied from the wrong controller and
overwritten your primary controller.
To Next Page
Loading...