Intermec EasyCoder PC4 Installation Instructions

6 EasyCoder PC4/PC41 Mobile Battery Unit Installation Instructions
Chapter 2 — Operation
Operating on Battery Power
1 Operate the printer normally until the battery power indicator
switches from green (power on) to amber (power low warning). You
should be able to use the printer for an average of eight (8) hours
without battery recharge.
When the battery power switches from green to amber, you
will still be able to print several labels. When the indicator
switches to red, the battery unit is automatically switched
off to prevent battery damage. To continue printing, you
must either insert a charged battery or connect the power
supply adapter to the battery unit.
2 Switch the battery unit off , when it is not connected to the printer, or
when not printing for a long time, to avoid unnecessary draining of
the battery pack.
3  e battery pack is charged by connecting the battery unit to the
printer's power supply adapter.  e charging time is approximately
four hours.  e battery unit must be ON to charge.
4  e battery pack can also be charged while connected to an active
printer if the battery pack is connected to the power supply adapter
and the battery pack switch is ON.
Refer to the illustrations on the next page!

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing