Co de 39
Nugget
Operating the Terminal in a Network
4-9
4
You can install the T2425s and access points in one IP subnetwork and install the
DCS 300 in another IP subnetwork as shown in the illustration below. In this network,
you must configure additional network parameters (default router and subnet mask) as
described later in this chapter.
Note:
All access points that the T2425 may communicate with and roam between must
be on the same IP subnetwork. The terminal cannot roam between IP subnetworks.
T2425s Communicating Across Subnetworks (UDP Plus)
Access point
192.9.200.X
subnetwork
192.9.175.X
subnetwork
TRAKKER Antares 2425 terminals
Ethernet
Router
242XU.092
192.9.175.1
192.9.200.5
192.9.175.9
192.9.175.10
192.9.175.11
DCS 300
To Next Page
Loading...
