UM094TW / UM594TW UDM094-04
28
S
ET
-U
P
P
ROCEDURES
8. Relocating Operator Controls
This case sealer is shipped with the operator controls mounted on the left hand side of the
machine (when viewed from the in feed of the machine). Certain machines have the ability to
relocate the operator controls to the opposite side.
Figure-13
Re-Locating Adjustment Handles.
Figure-14
a. Loosen 3 mm Allen Screw to allow removal of Handle from Square Shaft.
b. Remove Adjustment Handle from Square Shaft and re-locate to Right Side.
c. Re-Tighten Allen Screw to lock Adjustment Handle to Square Shaft.
To Next Page
Loading...