Intex CS7110 User Manual

Page 2
(188PO) MODEL CS8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
English
188
PO
S AVE THESE INSTRUCTIONS
English
Page 17
OPERATION INSTRUCTIONS
1. Turn on the filter pump.
2. Start up the unit:
Plug the power cord into the
electrical outlet and test the
 GFCI/RCD(circuitbreaker).
 Switchontheunit.Flashingcode“00” 
appears on the electronic control station’s
LED, indicating that the unit is ready to be
programmed.
3. Set operating hours for Saltwater system:
With code “00” flashing, press button to
set the desired operating hours. See the
“Operating Time Table” for the required
operating hours related to each pool size.
Pressing will increase the time from 01
to 12 hours maximum. If you have selected
too many hours keep pressing to repeat
the cycle. The built-in timer will now activate
your Saltwater System, at the same time
each day, for the number of hours you have set.
NOTE: The Saltwater System will not operate if the filter pump is not operating.
 Makesuretoprogramyourfilterpump(orstartitmanually)foroperationbeginning5
minutes before the saltwater system and finishing 15 minutes after the saltwater system.
4. Lockkeypadcontrols:
With the desired hour value showing, press button until you
 heara“beep”.Agreen“WORKING”indicatoronthecontrolpanel
will light up within a few seconds to indicate that the saltwater system
has started chlorine production. Locking the control buttons into this
setting prevents unauthorized changing of the operating cycle.
NOTE: If you forget to lock the keypad controls, the system will
automatically lock it and start working 1 minute later.
5. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary.
Press button until you hear a “beep” to unlock the keypad and the
current programmed time will flash. Repeat steps 3 to 4.
6 . Test the copper concentration in the pool water.
The Saltwater System recommends a copper level of 0.1 to 0.2 ppm.
This is easily tested by the copper ion test strips provided. If the test
result is 0.1~0.2 ppm, go directly to step 8.
(1to12hoursmaxpercycle)
OK
0
Copper (ppm)
0.1 0.2 0.5 0.9 1.3

Intex CS7110 Specifications

General

Brand	Intex
Model	CS7110
Category	Water System
Language	English