Intex CS7110 User Manual

Page 2
(188PO) MODEL CS8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
English
188
PO
S AVE THESE INSTRUCTIONS
English
Page 19
LED CODE CHART
LED Reading Definitions
80 BoostMode
 00 Stand-ByMode(Start-up)
 01 MinimumOperatingHour(1hourremaining)
 02 OperatingHours(2hoursremaining)
 03 OperatingHours(3hoursremaining)
 04 OperatingHours(4hoursremaining)
 05 OperatingHours(5hoursremaining)
 06 OperatingHours(6hoursremaining)
 07 OperatingHours(7hoursremaining)
 08 OperatingHours(8hoursremaining)
 09 OperatingHours(9hoursremaining)
 10 OperatingHours(10hoursremaining)
 11 OperatingHours(11hoursremaining)
 12 MaximumOperatingHours(12hoursremaining)
 90 AlarmCode(LowPumpFlow/NoPumpFlow)
 91 AlarmCode(LowSaltLevel)
 92 AlarmCode(HighSaltLevel)
 93 Stand-ByMode(OperatingProcessfinished)
 “BLANK” NoPoweror“PowerSavingMode”waitingtostartnext
Saltwater System cycle.
IMPORTANT
When Code “90” alarm is shown, ensure the timer of the filter pump is set one (1)
hour longer than the Saltwater System.
If the filter pump does not have a built-in timer, the filter pump needs to be turned
on/off manually every day.

Intex CS7110 Specifications

General

Brand	Intex
Model	CS7110
Category	Water System
Language	English