Intex CS7110 - Page 8

Page 2
(188PO) MODEL CS8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
English
188
PO
S AVE THESE INSTRUCTIONS
English
Page 8
SETUP INSTRUCTIONS (continued)
1. Godirectlytostep2ifyourpoolisempty.Ifyourabove-ground-poolisfilledwithwater,
unscrew the strainer grids from the strainer connectors and insert the black hat-like plugs
into the connectors, before installing the saltwater pool system.
2. Connect the adaptor A (1) to the electrolytic cell (4) outlet as shown in Drawing #1. Tighten
securely.
3. Disconnect the water return hose from the filter pump connection and connect it to the
adaptor A (1)ontheSaltwaterSystemwithahoseclamp.(seeDrawing#1)
4. ConnectadaptorB(9) to the connector hose (8).Tightensecurely.(seeDrawing#1)
5. ConnectadaptorB(9) tofilterpumpoutlet(lowerconnection).Tightensecurely.
6. Remove the black hat-like plugs that prevent water from flowing out of the pool. Now,
return the strainer grids to the strainer connectors.
8
9
1
4
8
9
Filter
Pump