Intex CS7110 User Manual

Page 2
(188PO) MODEL CS8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
English
188
PO
S AVE THESE INSTRUCTIONS
English
Page 9
SETUP INSTRUCTIONS (continued)
Connecting the system to pump and pool with 1-1/2” (38mm) connections/hoses:
Pump and pool with 1-1/2” (38mm) connections do not require the adaptors A (1) or B (9).
Install as follows:
Drawing #2
1. Godirectlytostep2ifyourpoolisempty.Ifyourabove-ground-poolisfilledwithwater,
close the plunger valves before installing the Saltwater System.
2. Disconnect the water return hose from the filter pump connection and connect it to the
Saltwater System outlet.
3. Connect the connector hose (8) to the filter pump outlet connection.
4. Open the plunger valves to allow the water to flow.
FILTER
PUMP
ID1-1/2”(38mm)
HOSE
ID1-1/2”(38mm)
HOSE
SALTWATER
SYSTEM
SWIMMINGPOOL
WATER TO
POOL
PLUNGER
VALVE
WATERFROM
POOL
8

Intex CS7110 Specifications

General

Brand	Intex
Model	CS7110
Category	Water System
Language	English