Intex Krystal Clear SF90110T - Common Pool Problems

193
PO
SAVE THESE INSTRUCTIONS
(193PO) MODEL SF90110T SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/21/2013
English
Page 21
COMMON POOL PROBLEMS
PROBLEM DESCRIPTION CAUSE SOLUTION
ALGAE
COLORED
WATER
FLOATING
MATTERIN
WATER
CHRONICLOW
WATER LEVEL
SEDIMENTON
POOL BOTTOM
SURFACE
DEBRIS
•ChlorineandpHlevels 
need adjustment.
•Copper,ironormaganese
in water being oxidized by
the added chlorine.
This is Common.
•"Hardwater"causedbya
too high pH level.
•Chlorinecontentislow.
•Foreignmatterinwater.
•Riporholeinpoollineror
hoses.
•Thedrainvalvesareloose.
•Heavyuse,gettinginand
out of pool.
•Pooltooclosetotrees. 
• Superchlorinatewithshock 
treatment. Correct pH to your
pool store's recommended level.
• Vacuumpoolbottom.
• Maintainproperchlorinelevel.
• AdjustpHleveltothe
recommended level.
• Runfilteruntilwaterisclear.
• CorrectthepHlevel.Checkwith
your pool dealer for advice.
• Adjustthechlorinelevel.
• Repairwithapatchkit.
• Fingertightenallcaps.
• UseIntexpoolvacuumtoclean
of pool.
• UseIntexpoolskimmer.
•Greenishwater.
•Greenorblackspots
on pool liner.
•Poollinerisslippery
and/or has a bad odor.
•Waterturnsblue,
brown, or black
when first treated
with chlorine.
•Wateriscloudyor
milky.
•Levelislowerthan
on previous day.
•Dirtorsandonpool
floor.
•Leaves,insectsetc.
IMPORTANT
If you continue to experience difficulty, please contact our Consumer Service Department for
assistance. See separate “Authorized Service Centers” sheet.