Intex Quickfill AP619D User Manual

(17PO) AP619D/AP619DP-22 ELECTRIC PUMP ENGLISH 4.875” X 7.25” 12/04/2021
English
17PO
READ AND SAVE THESE INSTRUCTIONS
Page 5
1. Open cord compartment cover and locate the
manual inflation port.
2. Make sure the control dial of the internal electric
pump is still in the closed / pump off position.
3. Remove the cap from the manual inflation port and
insert the nozzle of the pump into the port. Inflate the
airbed to desired firmness.
NOTE: Do not overinflate. The firmness should be
approximatelythesameasthelevelachievedwiththe
internal electric pump.
4. Remove nozzle from manual inflation port and close
the cap and the cord compartment cover.
STORAGE INSTRUCTIONS
1. Deflatetheairbedfollowingthe“DEFLATION”instructions.
2. Make sure the airbed is clean and dry.
3. Laytheairbedflatwiththesleepingsurfacefacingupwardsandfollowthefoldingsteps
on Figs(8-12).Foldtheairbedlooselyandavoidsharpbends,cornersandcreases
which can damage the airbed.
REPLACING INTERNAL AIR PUMP OR THE AIRBED COMPONENT
If there is a need to replace either the internal air pump or the airbed portion, detach the
internal pump from the airbed as follows:
1. While holding both lock tabs pressed inward(seeFigure13), turn the round body of the
 pump(thelargeouterrim,notthe control dial)counterclockwiseandpulltheairpump
body out of the holder frame.
2. Dependingonwhichpartisbeingreplaced,keeptheremainingcomponent(eitherthe
 airbedportionortheremovedpump)inasafeplaceuntilthereplacementpartis
received. Reattach the components when the new part is received: simply place
the pump into the holder frame and turn clockwise untill the lock tabs click into place.
NOTE: Make sure the rubber seal on the pump housing as well as the inside wall of the
holder frame are clean and free from any lint, hair or dirt, to ensure a proper seal and avoid
air leaks.
NOTE: Do not remove internal air pump from the holder frame other than for servicing, as
this may introduce lint, hair or dirt into the seal area and cause air leaks. If air leak is
experienced,checkthatthesealiscleanbeforereplacingthepumportheairbed.
FIG (7)
FIG (8)
FIG (9)
FIG (10)
FIG (12)
FIG (11)
FIG (13)
1
2
1

Intex Quickfill AP619D Specifications

General

Brand	Intex
Model	Quickfill AP619D
Category	Water Pump
Language	English