Intex Quickfill AP619D - IMPORTANT NOTE; DEFLATION; MANUAL INFLATION OPTION

(17PO) AP619D/AP619DP-22 ELECTRIC PUMP ENGLISH 4.875” X 7.25” 12/04/2021
English
17PO
READ AND SAVE THESE INSTRUCTIONS
Page 4
Proper inflation of the airbed.
The ambient temperatures of air have an effect on the airbed internal pressure. At low
ambient temperature the air will contract within the airbed and the airbed will feel softer:
addairasnecessary.Athighambienttemperaturetheairwithintheairbedwillexpand
significantly and the airbed will become hard and may burst: release air to avoid damage
to the airbed or to soften the feel. Do notexposetheairbedtoextremetemperatures
(hotorcold).
Stretchingisanaturalcharacteristicofnewvinyl.Duringinitialuse,theairbedmaybecome
softandrequireadditionalinflationtomaintaindesiredfirmness.Thisisnormalforthefirst
few days of use.
Dimensionsshownareapproximateandwillvaryduetothevinyltemperatureandtheair
temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the airbed caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.
IMPORTANT NOTE
DEFLATION
1. PlugintheACpowercordintoanACelectricaloutlet.SeeFig(2).
2. Turn the control dial fully counterclockwise until it stops. The pump is now deflating the
airbed.SeeFig(5).
3. When all the air is removed from the airbed, turn the control dialback(clockwise)tothe
center position which closes the valve and turns the pump off.
4. DisconnecttheACpower cord from the electrical outlet, coil the power cord and place it
inside the cord compartment, then close the cover. Make sure the power cord is free of
twists, kinks or knots.
5. With the airbed fully deflated begin rolling the airbed from the end opposite of the pump
 towardstheendwherethepumpislocated.SeeFig(6).
MANUAL INFLATION OPTION
If electrical power is not available, a conventional foot, manual, or battery-operated air
pump can be used by connecting it to the manual inflation port located inside the power cord
compartment. SeeFig(7).Followthesesteps:
FIG (5)
Deflate
Position
FIG (6)