To Next PageTo Next PageHow to troubleshoot Intex SF70220RC-2 motor that fails to start?
If the Intex Water Filtration Systems's motor doesn't start, ensure the line cord is plugged into a 3-wire outlet protected by a Class A Ground Fault Circuit Interrupter, or RCD. Also, reset the circuit breaker if it has tripped; repeated tripping may indicate an electrical system defect requiring an electrician. If the motor is too hot, allow it to cool down before restarting.
What to do if the Intex Swimming Pool filter motor fails to start?
If the Intex Swimming Pool filter motor won't start, ensure it's properly plugged into a 3-wire outlet protected by a Class A Ground Fault Circuit Interrupter (GFCI) or RCD. Also, check if the GFCI/RCD circuit breaker has tripped and reset it. If it repeatedly trips, there may be an electrical defect requiring an electrician. If the motor is too hot, let it cool down before restarting.
Why is the timer on my Intex Swimming Pool inaccurate or can't be set?
If the timer is inaccurate or can't be set on your Intex Swimming Pool, turn off the pump and restart 5 minutes later. Reset the timer. If the issue persists, contact the Intex service center.
What to do if the Intex Swimming Pool pressure gauge doesn't work?
If the pressure gauge on your Intex Swimming Pool doesn’t work, clear any obstructions in the intake by unscrewing it from the 6-way valve. If the pressure gauge is damaged, contact the Intex service center.
How do I fix a leaking hose on my Intex Swimming Pool?
If the hose is leaking on your Intex Swimming Pool, tighten or reinstall the hose nut securely. Ensure the o-ring or L-shape o-ring is in place at the hose connection fitting and not damaged.
How to fix an Intex Swimming Pool inlet threaded air connector/air jet valve leak?
If the inlet threaded air connector or air jet valve is leaking on your Intex Swimming Pool, tighten or reinstall the plunger valve to ensure it is well-fitted. Tighten the air jet valve and make sure it’s facing up. If the air jet valve internal seal is blocked, turn the pump ON and run for a few seconds, then turn OFF, repeat 3 times. If the air jet valve internal seal is dirty, remove the air jet valve, flush dirt out with water, and replace the valve back. If the air jet valve is broken, replace it with a new one.
What causes the 6-way valve/cover to leak on my Intex Swimming Pool?
If the 6-way valve or cover is leaking on your Intex Swimming Pool, remove the 6-way valve cover and ensure the o-ring is in place. Clean the sand tank o-ring with garden hose water if it's dirty. Tighten the flange clamp securely. If the 6-way valve is damaged, contact the Intex service center.
How to stop sand from flowing back into the Intex Swimming Pool?
If sand is flowing back into your Intex Swimming Pool, ensure you're using No. 20 silica sand with a particle size range of 0.45 to 0.85 mm (0.018 to 0.033 inches) and a Uniformity Coefficient less than 1.75. Also, change the sand if the sand bed is calcified.
What to do if Intex Swimming Pool pump doesn’t work?
If the Intex Swimming Pool pump isn’t working, ensure the pool is filled to the correct water level. Clean the strainer screens at the pool inlet. Tighten hose nuts and check the hose for damage to address any air leaks on the intake hose. For a faulty motor or jammed impeller, contact the Intex service center.
Why doesn't my Intex Swimming Pool filter clean the pool?
If the Intex Swimming Pool filter isn’t cleaning the pool, adjust the chlorine and pH levels. Ensure the filter tank is loaded with filter sand according to the “sand loading instructions”. Set the 6-way valve to the “FILTER” position. If the pool is excessively dirty, operate the filter for longer periods. Clean the strainer screen at the inlet if it's restricting water flow.
General| Brand | Intex |
|---|---|
| Model | SF70220RC-2 |
| Type | Sand Filter Pump |
| Voltage | 110-120V |
| Power Source | Electric |
| Filter Media | Sand |
| Hose Diameter | 1.5 inch |
Essential safety guidelines before installing and using the product.
Explains the different settings and water flow for the 6-way valve.
Crucial safety instructions for ladder installation and use.
Crucial safety instructions for pool installation and use.
