193
PO
SAVE THESE INSTRUCTIONS
(193PO) MODEL SF90110T SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/21/2013
English
Page 13
SAND FILTER PUMP HOSE CONNECTION SETUP (continued)
For INTEX pool size 16' and below:
1. In a counter-clockwise motion unscrew plunger valve union from the threaded strainer
connector (26). Be careful not to lose the step rubber washer (23).
2. Grasptheplungervalveassembly.Makesurethestepwasher(23) is in place. Connect
adaptor B (28) to plunger valve union.
3. Remove wall plug and then insert the strainer (29 & 31) into the lower position of protruding
hose connection, and the nozzle (29 & 30) into the upper position of protruding hose
connection. Adaptor B (28) fits over the strainer connection (29) inserted into the connection.
Tighten securely.
4. Remove the drain cap (3) before attaching the drain/waste hose or pipe.
For NON-INTEX pool:
Connect the hose (12) to the pool inlet/outlet connection with a large hose clamp. Tighten
securely. Remove the drain cap (3) before attaching the drain/waste hose or pipe.
POOL
LARGE HOSE
CLAMP
12
3
POOL
29 & 30
29 & 31
3
28
To Next Page
Loading...
Need help?
General
