EasyManuals Logo

Intex SF90110T User Manual

Intex SF90110T
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background image
193
PO
SAVE THESE INSTRUCTIONS
(193PO) MODEL SF90110T SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/21/2013
English
Page 14
OPERATING INSTRUCTIONS
• Riskofelectricshock.Connectthisproductonlytoagroundingtypereceptacle
protected by a ground-fault circuit interrupter (GFCI) or residual current device (RCD).
Contact a qualified electrician if you cannot verify that the receptacle is protected by a
GFCI/RCD. Use a qualified electrician to install the GFCI/RCD, which has a maximum
rate of 30mA. Do not use a portable residual current device (PRCD).
To reduce the risk of electric shock, do not use extension cords, timers, plug adaptors
or converter plugs to connect unit to electric supply; provide a properly located outlet.
• Do not attempt to plug in or unplug this product while standing in water or when your
hands are wet.
• Neveroperatethisproductabovethemaximumworkingpressurestatedonthefilter
tank.
• Alwaysswitchoffpumpbeforechangingthe6-wayvalveposition.
• Operatingthisproductwithoutwaterflowingthroughthesystemcancauseabuildup
of hazardous pressure which can result in an explosive situation, serious injury,
property damage or death.
• Nevertestthispumpwithcompressedair.Neveroperatethesystemwithwater
temperature above 35° C (95° F).
Valve Position Function Water Flow Direction
FILTER
(see drawing 23)
Normalfiltrationandregularvacuuming
of pool
From pump through filter media to
pool
BACKWASH
(see drawing 24)
Reverses water flow to clean filter
media
From pump through filter media to
valve waste/drain outlet
RINSE
(see drawing 25)
For initial startup cleaning of the sand, and
leveling the sand bed after backwashing
From pump through filter media to
valve waste/drain outlet
WASTE
(see drawing 26)
For vacuuming directly to waste,
lowering pool level or to drain the pool
From pump to valve waste/drain
outlet bypassing the filter media
RECIRCULATE
(see drawing 27)
For circulating water back to pool
without going through the filter media
From pump through valve to
pool bypassing the filter media
CLOSED
(see drawing 28)
Shuts off all flow to filter and pool
“Do not use this setting with pump running”
6-way valve positions and function:
WARNING
23
24
25

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex SF90110T and is the answer not in the manual?

Intex SF90110T Specifications

General IconGeneral
BrandIntex
ModelSF90110T
CategorySwimming Pool Pump
LanguageEnglish

Related product manuals