Intex ZX100 User Manual

(77IO) ZX100 AUTOMATIC POOL CLEANER ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 06/22/2022
77
A
S AVE THESE INSTRUCTIONS
Page 10
SETUP INSTRUCTIONS (continued)
10.
Turn on the filter pump and make sure water is flowing through the micro-screen
(6) and the pressure release valve (7). The auto cleaner is now moving and
vacuuming the pool floor and pool wall. See Fig. 10.
Note: The cartridge filter pump or sand filter pump will clean the pool water.
It’s essential to clean or replace the filter cartridge or backwash sand media
frequently to keep the water clean.
If the Auto Cleaner is paired up with a sand filter pump, the system flow will
diminish and the pressure will rise as indicated by the sand filter pump
pressure gauge reading (from green to yellow zone), this is normal. Disconnect
the Auto Cleaner from the pool and check if the sand filter pressure gauge
reading will drop back to the green zone. Refer to the sand filter pump manual
for more details.
10
6
7
If the auto cleaner starts to stir the debris, sediments on the pool floor,
you will require to clean or replace the filter cartridge more frequently as
the fine sediments are retained by the cartridge. In the case of a sand
filter pump, backwash the sand media more frequently. Also clean the
debris net (3) frequently.
IMPORTANT NOTE

Intex ZX100 Specifications

General

Material	Plastic
Pool Type	Above Ground, In Ground
Cleaning Coverage	Floor
Cleaning Cycle Time	2 hours
Color	Blue