10
SELECTING ID TO BE CREATED
Enter the EDIT mode by pressing the keys.
To create ID 803, press followed by The ITL950C will display EDITING ID
803. You have now set the lD number to be edited.
Press
, screen will display ENABLE PAUSE (Y or N) press to toggle. Pause is
used with keys that require different cut angles as with MEDECO(c), safety deposit box keys and
other flat steel keys. When pause is enabled, the machine will stop the cutter after each cut.
SETTING TIP TYPE
Press , screen will display TIP TYPE = 3. The tip type in an ID determines which reference
point is used to cut a key. To enter the new tip type of 2 press .
TABLE OF TIP REFERENCE POINTS
TIP REF # OFFSET RANGE OF SPACES NOTES
0 0.000 INCHES 0.001-1.350 INCHES SHOULDER REFERENCE
1 1.025 INCHES 0.000-0.749 INCHES SAFETY DEPOSIT KEYS
2 1.150 INCHES 0.000-1.149 INCHES USE INSERTS 1A, 1B, 1S.
3 1.350 INCHES 0.000-1.349 INCHES REFERENCE FROM
RIGHT VISE EDGE
SELECTING A FLAT
Press the lTL950C now displays FLAT NUMBER —.
The flat determines how wide the bottom of each cut will be. Note: flat 1 produces the same
width as the cutter being used.
The flat ranges from 1 through 10. To select flat 4, press , followed by . The
display will now show FLAT 4. Refer to the table of flats on page 8.
SELECTING INSERT NUMBER
Press the ITL950C will now show INSERT —. Refer to the following table for further
information on inserts. To select insert 3, press followed by . The display will now show
INSERT 3. Press to continue. Clear may be used to correct entries or return to edit mode.
To Next Page
Loading...