129
NOTE
Re-assembly is done in reverse order. Ensure that the tyre is replaced on the same side and in
the same travel direction as it was previously mounted.
Repairing the flat tyre
EXPLOSION HAZARD!
The wheel will explode if you do not let the air out of the tyre before removing the wheel!
• Always let the air out of the tyre before removing it (press in the pin in the middle of the
valve)!
• Unscrew valve cap.
• Depressurise tyre completely by pressing in the pin in
the valve .
• Remove the 5 cylinder head screws (back of the
wheel, 2.
• Remove the rim halves from the tyre.
• Remove the inner tube from the tyre.
• Repair inner tube and replace, or insert new.
NOTE
If the old inner tube is to be repaired and re-used, and has become wet during repair, you can
make replacement easier by sprinkling the inner tube with a little talcum powder.
To Next Page
Loading...
