68
• Remove the seat cushion.
• Remove the cover plates (1).
• Undo the two Allen screws (6) at the rear on the crossmember and remove them.
• Undo the two Allen screws (9) at the front on the seat support plate and remove them.
• Loosen the four Allen screws (7) and (8) which are located at the front and back to the sides of
the seat support plate to release tension so that the plate can be moved more easily. Do not,
however, remove these screws completely.
• Pull or push the seat support plate (2) the required width. A scale (3) has been fitted to the
bottom part of the seat support. Use this scale to read off the seat width in centimetres.
• Repeat these operations on the other side of the seat.
• Now tighten all the screws again.
To Next Page
Loading...
