INVENTOR ATM04S User Manual

98
Matrix Mono
Inventor Matrix Mono Engineering Data Book
Step 11. Select the “KJRH-120F/
BMKO-E”
Step 12. On the wired controller, select “MENU”, then “WLAN SETTING” and
press “OK”. Select “AP mode” and press ok. Click once the right buon to
selecty the “OK” command, and please “OK” to enter the WiFi mode. The WiFi
icon on the wired controller will start ashing. Make sure you complete the
operaon in 90 seconds aer the icon starts ashing. Check the “Operaon
completed on the boom part of the screen of the mobile/tablet, and select
the “Next step” to connue”.
Step 13. Select “Set up WiFi”
to nd and connect to the heat
pump’s WiFi.
Step 14. In your device’s wi
networks, nd the net_xx_xxxx
network and press to connect. The
password is “12345678”.
Step 15. Once connected to the
device’s wi, return to the APP. The
process will automacally proceed.
Allow for a few minutes for the
process to complete.

INVENTOR ATM04S Specifications

General

Brand	INVENTOR
Model	ATM04S
Category	Air Conditioner
Language	English