To Next PageTo Next PageWhat to do if Invertek Drives ODE-3-140022-3F12 DC Drives displays 'Motor Thermal Overload (I2t)'?
If the Invertek Drives DC drive displays 'Motor Thermal Overload (I2t)', check that the supply voltage is within the allowed tolerance for the drive.
Why does my Invertek Drives ODE-3-140022-3F12 show Output Over Current?
If the Invertek Drives DC drive trips due to output over current, after delivering more than 100% of the value set in P-08 for a certain time, it is designed to prevent motor damage. This can be caused by excess load or shock load on the motor.
What to do for Autotune Fault on Invertek Drives ODE-3-140022-3F12?
If the Invertek Drives DC drive shows an Autotune Fault, where the motor parameters measured during autotune are incorrect, check the motor cable and connections for continuity.
How to fix brake channel over current on Invertek Drives DC Drives?
To address a brake channel over current issue in your Invertek Drives DC drive, check the external brake resistor's condition and the connection wiring.
What does Brake resistor overload mean on Invertek Drives ODE-3-140022-3F12?
If the Invertek Drives DC drive indicates a brake resistor overload, it means the drive has tripped to prevent damage to the brake resistor.
How to resolve over voltage on DC bus in Invertek Drives ODE-3-140022-3F12 DC Drives?
If the Invertek Drives DC drive reports an over voltage on the DC bus, especially during deceleration or stopping, increase the deceleration time in parameter P-04. Alternatively, install a suitable brake resistor and activate the dynamic braking function using parameter P-34.
Why is my Invertek Drives DC Drives showing 'Drive internal temperature too high'?
If the Invertek Drives DC drive reports 'Drive internal temperature too high', it means the drive's ambient temperature is too high. Ensure adequate cooling air is provided to the drive.
What causes Motor PTC thermistor trip on Invertek Drives ODE-3-140022-3F12?
If the Invertek Drives DC drive trips because of motor PTC thermistor over temperature, it means the connected motor thermistor has detected over temperature. Check the wiring connections and the motor itself.
What does Output Fault mean on Invertek Drives ODE-3-140022-3F12 DC Drives?
If the Invertek Drives DC drive indicates an output fault, which may be due to a missing phase or unbalanced motor phase currents, check the motor and its connections.
How to fix heatsink over temperature on Invertek Drives DC Drives?
If the Invertek Drives DC drive's heatsink is overheating, ensure the ambient temperature around the drive is within the specified limits.
General| Brand | Invertek Drives |
|---|---|
| Model | ODE-3-140022-3F12 |
| Category | DC Drives |
| Language | English |
Critical safety precautions before installation and operation.
Step-by-step guide for initial setup and basic operation.
How to identify the Optidrive E3 model number and its components.
Overview of power and control connections, including essential PE grounding.
Procedures for connecting the incoming power supply, including cable and protection selection.
Guidelines for connecting the motor to the drive, including cable types and lengths.
Detailed descriptions of standard operational parameters for the drive.
Overview of Modbus RTU protocol, its specification, and RJ45 connector.
Comprehensive list of fault codes, their descriptions, and suggested remedies.
