39
The device does not work, no light:
Check the mains connection and the main fuse.
No response to the DMX controller:
Check the DMX connectors and cables for correct connection. Check the address settings and the DMX polarity.
Check whether the DMX cables are near or next to high voltage cables. Try another DMX controller.
If the instructions given here do not lead to success, please contact your specialist dealer.
Cleaning and maintenance:
It is essential that you clean the projector at regular intervals. Disconnect the device from the mains before
maintenance work!
The objective lens should be cleaned on a weekly basis, since fog fluid residues settle very quickly, which
considerably reduce the luminosity of the device.
Clean the fan monthly.
The dichroic color filters, the gobo wheel and the inner lenses should be cleaned on a monthly basis.
In order for the bearings of the rotating parts to work well, they must be lubricated approximately every 6 months. For
oiling use a syringe with a fine needle. The amount of oil must not be excessive to prevent the oil from leaking while
rotating.
Maintenance and service work is reserved exclusively for authorized specialist personnel!
Outer diameter OD) 22,8mm / Inner diameter (ID) 19,5mm
25 channels or 30 channels
Powercon compatible input and output
Liquid-cooled with fan support
To Next Page
Loading...
