To Next PageTo Next PageWhat causes autotuning fault in INVT CHV100?
If the INVT DC Drives experience an autotuning fault, the motor rated parameters might be set improperly. Set the rated parameters according to the motor nameplate. Also, autotuning may be overtime, so check the motor’s wiring.
General| Protection Level | IP20 |
|---|---|
| Cooling Method | Forced air cooling |
| Enclosure Rating | IP20 |
| Output Power | 0.4kW~630kW |
| Control Mode | V/F control |
| Input Frequency | 50Hz/60Hz |
| Output Frequency | 0~600Hz |
| Protection Functions | Overcurrent, overvoltage, undervoltage, overload, overtemperature, phase loss, short circuit |
| Communication Protocols | Modbus |
| Operating Temperature | -10°C~+40°C |
| Braking | Built-in braking unit (optional), external braking resistor |
| Overload Capacity | 150% for 60 seconds, 180% for 3s |
| Ambient Temperature | -10°C to +40°C (derating above 40°C) |
| Storage Temperature | -20°C~+60°C |
| Altitude | Less than 1000m (derating above 1000m) |
| Humidity | Less than 95% RH, no condensation |
