INVT EVC16 Series - Page 11

11
over-voltage and under-voltage protection ; Load imbalance protection(only
applies to three-phase five-wire).
own control core.
Input connector
3 Pin terminal
5 Pin terminal
Note:8～10 AWG
Charge
interface
Quantity
one
-
Length
Charging gun wire , total length 5m(including 0.3m)
Note：
Customizable.
Type
EN IEC 62196-2016 : AC Type 2
-
Insulation
resistance
Input to
Output
Under normal atmospheric pressure , in the environment of relative
humidity ≤ 90% ， the insulation resistance between each live circuit and
between the live circuits and the ground is not less than 10MΩ at 1000V DC
voltage.
-
Input to PE
Output
to PE
Withstand
voltage
Input to
Output
AC2500V/1min/10mA
-
Input to PE
AC2500V/1min/10mA
-
Output
to PE
AC2500V/1min/10mA
-
Leakage
current
＜5mA（230V ac /400V ac 、50/60Hz input）
-
System parameters
Standby power
<5W
-
Shell Material
Plastic (ABS+PC)
-
Panel Material
Plastic (ABS+PC)
-
Appearance Size
width* height*depth:230*375*115(mm)
Tolerance ±2mm.
Network communication
2.4G WIFI Network
-
Networking Protocols*
Customizable OCPP1.6J
-
Start-up method
Swipe card to start, network to start (mobile APP)
-
charging method
Full of intelligence
-
Cool-down method
Natural cooling
Intelligent air cooling
-
Protection
IP54
Application environment
Indoor and outdoor parking charging station
Weight
About 3.5kg
About 4kg
About 5kg
Installation
Wall mounted installation; column type(option)
Accessories list
1. Charger; 2. Quick Reference Guide; 3. Factory test report; 4. RFID card;
5. Mounting bracket 6. Support rear plate 7. Screws 8.