3. Preparation for charger installation
3.1 General requirements
Obtain permission to install this charger in accordance with local regulations
The AC power supply is available at the installation position.
Make sure cur off the the cable power during installation
3.2. Environment and tool requirements
Prepare before installation:
Search and clean out a suitable installation location.
Ensure that the installation location has a walls to install this Charger. The bearing capacity of expansion bolts used to
secure the rear plate should not be less than 20kg.
In addition to the above, you may also need to prepare the following tools : Drilling machine, Wire stripper, Crimping pliers
insulation tape, pipe terminals, etc.
3.3 Unpack the Charger
Unpack the charger packing case.
Take the Charger out of the packing case.
Take out the packing materials and installation accessories then put them aside.
Check all parts to ensure that all materials have been delivered.
a. Charger; b. RFID card; c. Quick Reference Guide; d. Mounting bracket; e. Support rear plate; f. 5M4x12 Screws.
Check whether the charger and installation parts are damaged. Contact the manufacturer's local supplier representative or
after-sales service if it damage or parts
4. Electrical installation of charger
4.1 General Specification
Before operating the electrical installation, ensure you have understand the following electrical rules of the Charger:
For the charger model: EVC 16-AW7KGP1UE, it is suitable for 230VAC single-phase input:
To Next Page
Loading...
Need help?
General