INVT iMars BG10KTR

iMars grid-tied solar inverters Installation
23
4.3.1 Installation of inverter
Figure 4.5 Installation bracket of inverter
Table 4-5 Dimension of installation bracket
Inverter model
Spacing of installation hole
A(mm)*B(mm)
4kW / 4kW-S / 5kW / 5kW-S /
6kW / 8kW / 10kW
260*45
The procedures for installation of inverter are listed below:
(1) Use the punch positioning plate in the packaging box to determine the punch position. As
shown in Figure 4.6. Level the holes with a level ruler and mark it with a marking pen.
Figure 4.6 Determine the punch position
(2) Drill 4 installation holes on the wall with electric drill. As shown in Figure 4.7.