18
F3: SET
There are 10 different settings within the
SET section, which they are as follow:
OSD Hotkey
Port ID Display Position
Port ID Display Duration
Port ID Display Mode
Scan Duration
Scan-Skip Mode
Screen Blanker
Hotkey Command Mode
Hotkey
OSD Language
OSD Hotkey
This function allows you to switch the way
to trigger the hotkey between [Scroll Lock]
[Scroll Lock] and [Ctrl] [Ctrl]. Simply move the
red highlight bar to the hotkey setting that
you would like to choose and press [Enter].
Then press [Esc] to exit from this function.
F3: SET
Port ID Display Position
This function allows you to change the
position of the port ID that’s showing on the
screen as the image below. Simply change
the position by using the up, down, left and
right arrows to adjust to the place that you
want the port ID to show in the future and
press [Enter].
Port ID Display Duration
This function allows you to change the port
ID display duration between 3 seconds and
off. Simply move the red highlight bar to the
option that you would like to choose and
press [Enter]. Then, press [Esc] to exit this
function.
To Next Page
Loading...
Need help?
General
