Ionic Pro ELITE TA740 - Cleaning the Permanent Ionic Filter

9
CLEANING THE PERMANENT IONIC FILTER:
DISHWASHER
1. Put the permanent ionic lter into the dishwasher— making sure not to damage
or bend the blades.
2. Remove from dishwasher at the end of the cleaning cycle.
3. VERY IMPORTANT: Ensure that the permanent ionic lter is thoroughly dry
before installing it into the purier and resuming use.
4. Always make sure your air purier is turned o and unplugged before attempting
to vertically re-insert the permanent ionic lter.
HANDWASH
1. Place the permanent ionic lter into warm, soapy water and let stand for
approximately 10 minutes. See Figure 5.
2. Remove from water and rinse with warm water. Repeat as necessary. If your lter
is excessively dirty, you can use a soft bristle brush to clean the blades. Make sure
not to damage or bend the blades. See Figure 6.
3. You may use a household degreaser for severe smoke or grease build up on the
permanent ionic lter. Please follow the instructions for the household degreaser.
4. VERY IMPORTANT: Wait until the permanent ionic lter is thoroughly dry before
re-inserting it into the purier and resuming use.
5. Always maker sure your air purier is turned o and unplugged before attempting
to vertically re-insert the collection blade assembly and pre-lter.
NOTE: If you insert a wet part, the fan will not turn on and the CLEAN FILTER light
will go on. Simply take out the part and let it dry.
Figure 5 Figure 6
CLEANING AND MAINTENANCE