11
Start IP: Set the start IP address of the DHCP server pool, such as "192.168.20.100".
End IP: Set the end IP address of the DHCP server, such as "192.168.20.200".
3) Click Save.
3. Configure the DHCP server used to assign IP address to AP3
1) Click Add.
2) Configure the parameters in the window.
VLAN Interface: Select "vlan3".
IP Address: Set an IP address for the VLAN interface, such as "192.168.30.1".
Subnet Mask: You can keep the default value.
DHCP Server: Select "Enable".
Remark: Set a name for the DHCP server, such as "AP3".
Primary DNS: In this example, you can set the primary DNS IP address as the DHCP server IP
address "192.168.30.1".
Start IP: Set the start IP address of the DHCP server pool, such as "192.168.30.100".
End IP: Set the end IP address of the DHCP server, such as "192.168.30.200".
3) Click Save.
To Next Page
Loading...