97
2. Configure the DHCP server used to communicate with the APs
1) Click Add.
2) Configure the parameters in the window.
VLAN Interface: Select "vlan5".
IP Address: Set an IP address for the VLAN interface, such as "192.168.5.1".
Subnet Mask: You can keep the default value.
DHCP Server: Select "Enable".
Remark: Set a name for the DHCP server, such as "AP".
Primary DNS: In this example, you can set the primary DNS address as the DHCP server IP
address "192.168.5.1".
Start IP: Enter the start IP address of the DHCP address pool, such as "192.168.5.100".
End IP: Enter the end IP address of the DHCP address pool, such as "192.168.5.200".
3) Click Save.
To Next Page
Loading...