EasyManua.ls Logo

iPA SMART MUTT 9007M - Wheel Speed Sensor Configuration and Power Issues

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
29
4
5
6
6
SAL Sensor conguration error
SAR Sensor conguration error
Verify correct ABS conguration
using blink codes or other diagnostic
tools.
If needed, reset to the default ABS
conguration and power-up to initiate
auto-conguration.
3
4
13
13
6 1 Over-voltage Power supply diagnostic trouble
code. Go to Section F, page 28.
251 3
6 2 Low-voltage Power supply diagnostic trouble
code. Go to Section F, page 28.
251 4
6 3 Excessive power line resistance Power supply diagnostic trouble code. Go
to Section F, page 28.
251 13
7
7
1
2
MOD1 Hold solenoid shorted or open
MOD1 Release solenoid shorted or
open
Clear faults.
If faults return, replace the TABS-6
Module.
42
48
3,4,5
6 or 12
3,4,5
6 or 12
8
9
8
9
1
1
2
2
MOD2 Hold solenoid shorted or open
MOD3 Hold solenoid shorted or open
MOD2 Release solenoid shorted or
open
MOD3 Release solenoid shorted or
open
Static ABS Modulator Fault.
Go to Section H, on Page 30.
43
44
49
50
3,4,5
6 or 12
3,4,5
6 or 12
3,4,5
6 or 12
3,4,5
6 or 12
7
8
9
3
3
3
MOD1 ABS modulator dynamic error
MOD2 ABS modulator dynamic error
MOD3 ABS modulator dynamic error
Dynamic ABS Modulator Fault.
Go to Section H, on Page 30.
7
8
9
7
7
7
8
9
4
4
MOD2 Valve conguration error
MOD3 Valve conguration error
Verify correct ABS conguration using
blink codes or other diagnostic tools.
If needed, reset to the default ABS
conguration and power-up to initiate
auto-conguration.
8
9
13
13
10
10
1
2
Valve MOD1/2 low-side switch
shorted to ground
Valve MOD3 low-side switch shorted
to ground
Check for corroded/damaged wiring or
connectors between the ECU and MOD.
At the MOD harness connector, verify:
No continuity from modulator/AUX
leads to ground.
After repairs or if no issues found,
then clear faults
If faults return, replace the TABS-6
Module.
7
9
4
4
10 3 ABS modulator dynamic error - all
valves
Dynamic ABS Modulator Fault.
Go to Section H, on Page 30.
7 7
10 4 Excessive ABS activity Dynamic Wheel Speed Sensor Fault.
Go to Section G, on Page 29.
1 7
POWER
MODULATOR (MOD)
COMMON

Related product manuals