IPC ST-35IPC - 4 Specifications; General Specifications

Page.71.
Notice:
a. Don’t input any power into the “DC12/1A OUTPUT” port of the tester
b. Man-made damage is not within our company’s warranty
c. The IP tester ’s power output capacity is 1A. If the IP camera uses more than 1A, the tester will
automatically enter a protection mode
d. Disconnect all cables from the tester and reboot it to resume using the tester.
The IPC tester power output is close to 1A, if the IP camera’s power is over 2V, the tester will
auto enter protection mode. Disconnect all the connections of the tester and then connect the
tester with power adaptor to resume the tester.
e. Make sure the tester has a sufficient charge otherwise the tester will not able to provide enough
output power
4. Specifications
4.1 General Specifications
Model
IP Camera Tester
Display
New 3.5 inch IPS touch screen cctv tester 480x320resolution
Network port
10/100/1000M auto adjust, RJ45
WIFI
Built in WIFI,speeds150M, allows you to connect to a wireless network and
view IP cameras
H.265 Main stream
test
New hardware decoding,4K,H.265/H.264 camera image display by
mainstream testing
IP discovery
Auto-scan the whole network segment camera IP
Rapid ONVIF
Search camera quickly, auto log in and display image from the camera,
activate Hikvision camera
Hik test tool
Activate Hikvision camera, display image from the camera, modify IP, user
name and password parameters etc
DH test tool
Dahua camera test, modify IP, user name and password parameters etc