iPECS ES-3052GP - Page 89

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 89 –
ES-3052 Series
Remote Configures the logging of messages to a remote logging process 382
SMTP Sends an SMTP client message to a participating server 383
Configure Server Configures a list of recipient SMTP servers 383
Add Adds a recipient SMTP server 383
Show Shows configured SMTP servers 383
Configure General Sets SMTP status, e-mail source and destination addresses 383
LLDP 387
Configure Global Configures global LLDP timing parameters 387
Configure Interface
Configure General Sets the message transmission mode, enables SNMP notification,
and sets the LLDP attributes to advertise
389
Add CA-Type Specifies the location of the device attached to an interface 393
Show CA-Type Shows the location of the device attached to an interface 393
Modify CA-Type Modifies the location of the device attached to an interface 393
Show Local Device Information 396
General Displays general information about the local device 396
Port/Trunk Displays information about each interface 396
Show Remote Device Information 399
Port/Trunk Displays information about a remote device connected to a port on
this switch
399
Port/Trunk Details Displays detailed information about a remote device connected to
this switch
399
Show Device Statistics 404
General Displays statistics for all connected remote devices 404
Port/Trunk Displays statistics for remote devices on a selected port or trunk 404
PoE Power over Ethernet 406
Configure Global Displays the power budget for the switch 407
Configure Interface Configures port power parameters 408
SNMP Simple Network Management Protocol 410
Configure Global Enables SNMP agent status, and sets related trap functions 412
Configure Engine 413
Set Engine ID Sets the SNMP v3 engine ID on this switch 413
Add Remote Engine Sets the SNMP v3 engine ID for a remote device 414
Show Remote Engine Shows configured engine ID for remote devices 414
Table 6: Switch Main Menu (Continued)
Menu Description Page