iPECS ES-3052GP - Page 88

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 88 –
ES-3052 Series
Add Rule Configures packet filtering based on IP or MAC addresses and other
packet attributes
324
Show Rule Shows the rules specified for an ACL 324
Configure Interface Binds a port to the specified ACL and time range 339
ARP Inspection 340
Configure General Enables inspection globally, configures validation of additional
address components, and sets the log rate for packet inspection
341
Configure VLAN Enables ARP inspection on specified VLANs 343
Configure Interface Sets the trust mode for ports, and sets the rate
limit for packet inspection
345
Show Information
Show Statistics Displays statistics on the inspection process 346
Show Log Shows the inspection log list 348
IP Filter 349
Add Sets IP addresses of clients allowed management access via the
web, SNMP, and Telnet
349
Show Shows the addresses to be allowed management access 349
Port Security Configures per port security, including status, response for security
breach, and maximum allowed MAC addresses
351
Port Authentication IEEE 802.1X 353
Configure Global Enables authentication and EAPOL pass-through 355
Configure Interface Sets authentication parameters for individual ports
Authenticator Sets port authenticator settings 356
Supplicant Sets port supplicant settings 361
Show Statistics Displays protocol statistics for the selected port 363
Authenticator Displays protocol statistics for port authenticator 363
Supplicant Displays protocol statistics for port supplicant 363
IP Source Guard Filters IP traffic based on static entries in the IP Source Guard
table, or dynamic entries in the DHCP Snooping table
365
Port Configuration Enables IP source guard and selects filter type per port 365
Static Binding 367
Add Adds a static addresses to the source-guard binding table 367
Show Shows static addresses in the source-guard binding table 367
Dynamic Binding Displays the source-guard binding table for a selected interface 369
Administration 379
Log 379
System 379
Configure Global Stores error messages in local memory 379
Show Logs Shows logged error messages 379
Table 6: Switch Main Menu (Continued)
Menu Description Page