DO NOT add gasoline to the gasoline tank or connect
the Propane/LPG hose to the generator while the
generator is running.
1.Disconnect all electrical loads from the generator.
2. Stop the engine (generator). See the “Stopping the
Engine (Generator)” section for stopping procedure.
3a. Gasoline to propane/LPG
• Make certain the gasoline valve is fully closed
“OFF” (O) position.
• Flip the fuel source switch on the side panel to the
propane/LPG position.
3b.Propane/LPG to Gasoline
• Fully open the Propane/LPG cylinder knob.
• Make certain the propane tank is fully closed.
Page 23
• Turn the fuel valve to the “ON” (I) position.
• Flip the fuel source switch on the side panel to the
gasoline position.
4. Start the engine (generator). See the “Starting the
Engine (Generator)” section for starting procedure.
OFF
ON
To Next Page
Loading...
