- 50 -
4.8 Motion Detect
The Motion Detect menu contains the command and option that
allow you to enable and set up the motion detection feature of the
camera. The camera provides three detecting areas.
To enable the detecting area, select Window 1/2/3 from the pull-
down list, and then select Enable. When the detecting area is
enabled, you can use the mouse to move the detecting area and
change the area
coverage.
Name: Assign a name to the detecting area.
Threshold: Move the slide bar to adjust the level for
detecting motion to record video.
NOTE Sliding the Threshold bar to the right will decrease the sensitivity
of motion detection; sliding the Threshold bar to the left will
increase the sensitivity of motion detection.
To Next Page
Loading...