- 53 -
4.9.3 Event Configuration >> Motion Detect Trigger
Motion Detect Trigger: Select the Enable option to enable
the trigger function of the camera, so that you can send
captured images within the detecting area to the FTP server,
email receiver, or the Network Storage server, etc. You have
to configure corresponding settings, such as FTP server and
email server, to enable this feature. Please note that you
have to configure the related settings before enabling these
features.
- Schedule Profile: Select a schedule profile from the pull-
down list.
- Action: Set the trigger function to enable the White LED
light warning, or select the destination that the captured
images will be sent to: Trigger Out, Record to USB,
Record to Network Storage, Send Email, FTP Upload,
Instant Message, or Upload Image to Picasa.
4.9.4 Event Configuration >> Schedule Trigger
You can separately configure the schedule for trigger function
of the camera by Email, FTP, or Network Storage. Select the
Enable option on each item, and then select a Schedule
Profile from the pull-down list and set the Interval time.
NOTE If the setting value of the Storage Recording Time Per
Event option in General Setting is longer than the Interval
time in Network Storage Schedule, the recorded file will be a
continuous video clip.
For example, if you set the Storage Recording Time Per
Event as 10 seconds and the Interval as 5 seconds,
recorded file becomes a non-stop video clip because the
camera will record a 10-second video clip every 5 seconds.
To Next Page
Loading...
Need help?
General
