- 7 -
i. USB Unmount Button is used to remove the connected USB
device safely.
NOTE After long pressing the Unmount button for four seconds, the
Power LED starts flashing. When the Power LED resumes the
steady amber light, you can remove the USB device safely.
j. DC Power Connector connects the AC power adapter, in
order to supply power to the camera.
k. WPS Button (for wireless model) is used to protect your
WLAN. Instead of entering the network name (SSID), your
wireless network can be protected simply by pushing a button.
TIP For more information of using the WPS button, refer to the
instruction of the Web Configuration, Network >> Wireless >>
WPS Setting.
l. GPIO Connectors is used to connect the external devices.
m. Reset Button will restart the camera when it is pressed quickly;
when it is pressed and held for five seconds, the camera will
resume the factory default settings.
n. Wireless Antenna Connector (for wireless model) is used to
attach the external antenna.
o. Ethernet Cable Connector connects the network cable, which
supports the NWay protocol so that the camera can detect the
network speed automatically.
p. Audio-out Connector connects an external active speaker.
To Next Page
Loading...
Need help?
General
