What to do if iRobot Vacuum Cleaner red light is on and beeping?
If your iRobot Vacuum Cleaner shows a red light and beeps when you press Sweep or Mop, it means a sensor is activated, preventing it from starting. Try removing and reapplying the cleaning cloth, ensuring it doesn't overlap into the middle channel of the removable cleaning pad and isn't bunching up, which can prevent the pad from reattaching completely to the robot.
How to fix iRobot Vacuum Cleaner with solid red light?
If your iRobot Vacuum Cleaner shows a solid red light, it indicates a system error. To resolve this: * Press and hold the power button to turn the vacuum off. * Vigorously rotate both wheels for 15 seconds. * Place the vacuum on the floor and power it back on, ensuring a dry cleaning cloth is applied. If the red light disappears, press Sweep. If it persists, further assistance is needed.
Why iRobot Vacuum Cleaner red light blinks 2 to 6 times?
If the red light on your iRobot Vacuum Cleaner blinks 2 to 6 times, it means the vacuum is stuck and cannot free itself. Remove the vacuum from the area where it's stuck and restart it in a new location.
What to do if iRobot Braava 300 Vacuum Cleaner red light blinks 14 times?
If the red light on your iRobot Vacuum Cleaner blinks 14 times, it indicates that the motor is getting too hot. Turn the vacuum off and allow it to cool down completely before resuming cleaning.
Why iRobot Braava 300 red light blinks 15 times?
If the red light on your iRobot Vacuum Cleaner blinks 15 times, it means the vacuum is stuck in too small of an area and cannot free itself. Remove the vacuum from the confined space and restart it in a larger, more open area.
Why is my iRobot Vacuum Cleaner beeping and all lights are flashing?
If all the lights are flashing on the NSI and the buttons are beeping while charging, it indicates that an incompatible adapter is being used. Remove the incompatible adapter and use only the adapter included with your iRobot Vacuum Cleaner.
General| Brand | iRobot |
|---|---|
| Model | Braava 300 Series |
| Category | Vacuum Cleaner |
| Language | English |
Describes limitations and safety guidelines for using Braava, including warnings about water and use.
Explains the meaning of different light patterns on the robot's navigation system indicator.
Describes the light indicators on the NorthStar Navigation Cube for power and connection status.
Explains how Braava establishes a connection with the NorthStar Cube and indicates range.
How to start cleaning with dry or wet cloths by pressing the Sweep or Mop buttons.
Guidelines for cleaning the robot's exterior and tires, and how to store it between uses.
Explains error codes and solutions for the NSI during cleaning, such as system errors or overheating.
Explains error codes and solutions for the NSI during charging, such as charging errors or adapter issues.
Solutions for problems connecting or operating the NorthStar Navigation Cube, like no connection or cube turning off.
Solutions for issues with the Pro-Clean Reservoir Pad, such as leaking or not wicking fluid.
Addresses problems like small cleaning areas, improper driving, and backing up due to sensors or environment.
Solves problems related to resuming cleaning after pause and battery charging issues.
To Next Page
