Roomba Customer Support Booklet
Can’t find the answer to your support question? Call Roomba Customer Support at 1-877-855-8593 or email us at
roomba-support@irobot.com
Note that no lights will illuminate on Roomba when it is charging -- only the green
Charging Light on the Charger box itself will be lit. Also note that Roomba will not
operate while it is charging.
How do I remove the Battery Pack?
Turn Roomba's power off and empty the Particle Bin. Place Roomba upside
down on a flat surface. Place index fingers under guide tabs on either side of
Battery Pack. Pull upward to release the Battery Pack.
Installing batteries into the Virtual Wall Unit (and first-time use)
Whether you are using your Virtual Wall Unit for the first time, or the Unit requires
fresh batteries, the procedure is the same.
1. Open the Battery Door located on the bottom of the Virtual Wall Unit by
using a small Phillips-head screwdriver to unscrew the screw that holds
the door in place. Insert 2 new "D" size alkaline batteries by following the
"+" and "-" symbols. Note that batteries for the Virtual Wall Unit are not
included.
2. Replace the Battery Door and tighten the screw.
To Next Page
Loading...
