Iseki TM3245 - Power Take-Off (PTO)

OPERATION
47
Releasing Cruise Control
FIG. 78: Cruise control is released if the cruise control
lever, 3, is returned to neutral position gradually or brake
pedal, 1, is depressed.
CAUTION: If cruise control is released by
depressing brake pedal, it is dangerous be-
cause broke is engaged at the same time.
Except for emergency case, release the
cruise control by shifting cruise control le-
ver to neutral position gradually.
WARNING: Cruise control should only be
used in open spaces, without obstacles,
with unobstructed view or traveling on road.
You must also be thoroughly familiar with
releasing cruise control.
DIFFERENTIAL LOCK OPERATION
FIG. 79: Differential lock pedal, 1, should only be de-
pressed when required as steering ability is greatly
reduced. To engage the differential lock, depress the
clutch pedal and allow all rear wheel movement to stop.
Depress the lock pedal and slowly engage the clutch. To
disengage the differential lock, depress the clutch pedal.
The differential lock pedal should normally return to the
“off” position.
IMPORTANT: Depress the main clutch pedal and stop
the tractor before engaging the differen-
tial lock.
NOTE: Differential lock pedal is located at right side
(MechanicalTransmission)orleftside(Hydro-
static Transmission).
CAUTION: When the differential lock is en-
gaged, steering ability of the tractor will be
greatly reduced. Disengage before attempt-
ing a turn. Do not use during transporting
on road.
Differential lock pedal is located at left side
for hydrostatic transmission type, and right
side for mechanical transmission.
4-WHEEL DRIVE
FIG. 80 : The 4-wheel drive shift lever, 1, engages and
disengages the drive for the front axle. With the lever
down, the front axle (4WD) is engaged and power is
available to both front and rear axles. With the lever up,
the front axle is disengaged.
NOTE: Illuminate the monitor lamp on the meter panel
when pushing down the 4-wheel drive shift le-
ver.
1
24
1
FIG. 79
FIG. 80
3
FIG. 78