Isel LES4 - Declaration of Incorporation According to Machinery Directive 2006;42;EC Annex II B

LES
4, 5, 6
- 234xxx xxxx
12 / 62
Assembly instruction
1.4 Declaration of incorporation according to Machinery directive 2006/42/EC
Annex II B
The manufacturer
isel Germany AG
Bürgermeister-Ebert-Str., 40
D-36124, Eichenzell
hereby declares that the following product
product description:
ball screw unit with spindle drive LES 4, 5, 6
model name:
LES 4, 5, 6
item number:
234xxx xxxx
serial number:
meets the essential health and safety requirements of Machinery directive 2006/42/EC Annex II.
The following harmonized norms were applied:
DIN EN ISO 12100:2011-03
Safety of machinery - General principles for design - Risk assessment and risk reduction.
EN 60204-1:2006/A1:
2009/AC:2010
Safety of machinery - Electrical equipment of machines - Part 1: General requirements.
The technical documentation for this machine has been prepared in accordance with Annex VII, part B. The manufacturer undertakes to electronically transmit
these specific technical documentations to national authorities on request.
The authorized representative for the compilation of the special technical documentation is:
name:
Christian Bley
capacity:
CE Beauftragter
company:
isel Germany AG
address:
Bürgermeister-Ebert-Str., 40, D-36124, Eichenzell
The product (incomplete machine) is intended for incorporation into a machine or for assembly with other incomplete machines into a machine within the
meaning of MRL, 2006/42/EC, Article 1, Section (1), letter a.
The commissioning of the incomplete machine (product) is prohibited until the machine in which this product has been incorporated or of which it
is a component complies with the requirements of all relevant directives (especially MRL ) and this complete machine has a CE marking.
Eichenzell, 23.02.2021
Werner Kister, Chairperson isel Germany AG