Isel LES4 - Maintenance Plan; Fig. 27 - Lubrication Points of the Linear Unit LES

LES
4, 5, 6
- 234xxx xxxx
56 / 62
Assembly instruction
Fig. 27 - Lubrication points of the linear unit LES
Proceed as follows to lubricate the linear unit LES.
1. Remove the cover caps.
2. Position the guide carriage behind a lubrication hole. (see points)
3. Place the grease gun on all accessible grease nipples and lubricate the shaft slides, guide, ball screw nut and
ball screw. 2 - 3 strokes are sufficient.
4. Push the cover caps back in.
✓ The ball screw nuts of the linear unit are lubricated.
7.3 Maintenance plan
Maintenance interval
Activity to be performed
on request
Cleaning the linear unit
300 - 700 Operating hours
Relubrication guide carriage and ball screw nut with special grease from isel Germany AG
monthly
- Visual inspection of linear guide rail - wear
- Visual inspection of the toothed belt (tension, abrasion...)
- Acoustic check for unusual noise
every two years
- Replacement timing belt
- Check backlash-free guide carriage and ball screw