Maintenance work
Non-observance can lead to slight to severe injuries.
˃ Maintenance work may only be carried out by authorised and trained specialist
personnel (mechanical maintainer).
Basic lubrication
The drive components are lubricated with a special grease ex works. They can be started up immediately. The EC
safety data sheet according to Directive 93/112/EEC and ISO 11014-1 can be requested from the manufacturer.
Relubrication
For relubrication of linear bearings with shafts, only the special grease of isel Germany AG should be used.
Oil lubrication is possible and reduces heating at higher spindle speeds, but the mounting position must be
observed and the lubrication intervals are shortened every 40 to 60 operating hours.
The required grease can be ordered under the following part numbers:
● Item no. 299031 grease cartridge
● Part No. 931170 Grease gun
Grease characteristics
● enormous reduction in wear
● significantly less consumption
● miscible with lithium and calcium fats
● water-repellent
● highly resistant to cold, hot and salt water and solvents
● Temperature range: -25°C to 200°C, emergency operation >300°C
● up to 6 times longer service life
● extremely good adhesion to metal surfaces
Classification and labelling according to EU Directives 67/548/EEC and 88/379/EEC - Water hazard class 1.
To Next Page
Loading...