5 Assembly and commissioning
5.1 Assembly
Mounting on the guide profile
Free positioning
Fig. 15 - linear unit LES 4, 5, 6 for installation as free standing
You can place the linear unit on a frame, a work table or any other suitable stable base. Select
the installation location so that the product cannot fall down by itself or by an impact or
pulling on the cable.
Rack mounting (recommended)
Fig. 16 - linear unit LES 4, 5, 6 for rack mounting
The shaft mounting profiles have several T-slots on the underside to mount thelinear unit to your frame. These are
used to accommodate threaded rails or sliding nuts (accessories). Use fastening screws - M6 to mount the linear
unit from below on your frame.
To Next Page
Loading...